Dear all,
Last week I've protected my SONY smartphone (Z3) with front and back tempered glass.
Every day, the Z3 goes to a magnetic charging dock station but with its new thickness increased by 0,66mm (each tempered glass are 0,33mm thin), the smartphone becomes to thick and didn't fit into the dock.
So I've modelised a new adapter in SolidWorks and after some print tests, the Z3 goes again into the dock.
(Prints were done with the new ZORTRAX printer in the fablab - Vélizy - and each prints last about 30 minutes long).
1st print test with cubify printer. The printed part were to large and the finish was a disaster...
The second print succeed thanks to the ZORTRAX printer. The surface quality is good, the printed adapter perfectly fit into the Sony dock.
Thank you to Seb and Schub for their help !