I'll try to elaborate on the title. Here is a situation I have in mind:

When I try to make a report that contains equipotential data for Card12's terminals, that data does not show up and I can't figure out a way to make it show up.

I'm guessing it's because equipotential data is not stored for cable conductors that don't have "draw wire" representations elsewhere in the project? I know equipotential data passes through these line diagram cable conductors during "Renumber wires" process because the correct/same equipotential shows up on wiring on either side of them.

Can anyone confirm whether this interpretation is correct or not? And is there any way to know equipotential data for line diagram cable conductors that don't have "draw wire" representations elsewhere in the schematic?

Thanks!